blade cutting what knowledge needs to pay attention to

1, idle: in particular, the first use of a new base, the need to idle for about 30 minutes, the summer hot season needs to bring water idling, which aims to further eliminate welding head when matrix effects and enhanced blade rotating at high speed state to maintain the  masonry drill bits intrinsic quality of memory.
2, blocks of not less than 0.5m3, and placed securely, the bottom should be well-wood pad, plug SUCOOT prison, blocks should be located in symmetrical positions workbench, workbench cars and blocks to ensure the stability, without shaking , shaking phenomenon.
3, according to the blocks of length, width, height adjusting limit switch, the blade lift and skip the trip in a reliable and effective range. Saw blade should leave before sawing blocks up to 10 ~ 20mm. After sawing, saw cut should be left away from the blocks at the bottom of 20-40mm, knife blade to go about running, you should exit all blocks Jukou the blade from not less than 150-200mm, to prevent the blade hit Shortage material.
4, the blade idling stable only after a trial cut blocks are not allowed contact with the blade starts cutting edge blade, cutting blade rotation are not allowed to stop, to withdraw Jukou before stalling.
5, cutting blocks are shaking if found should immediately stop cutting the blocks to be firmly fixed before it can continue working, cutting, are not allowed to move in any blocks.
6, the cutting blade and found a  diamond discs significant slowdown or even clip knife phenomenon, it may be belt slippage, compression nut loose or too large depth of cut, the cutting speed is too fast and other reasons, should be timely adjusted.
7, the line speed should be processed stone hardness and wear resistance to adapt, line speed table are recommended cutting different types of stone. Tip: line speed is not high, an increase in cutting efficiency, will reduce the life of the blade. 8, feed rate, depending on the processing of the material properties of each material when the cutting depth must have a certain range of the feed rate, if the speed is too high, will accelerate the wear of diamond or even fall off, causing the blade consumption too fast, if the speed is too low, then they will make the process of self-sharpening blades can not be normal, so "blunt, skid" lost cutting capacity. Under normal circumstances, the feed speed is slower when cutting, sawing should be in uniform for the common typical materials, when the cutting depth is 20mm, recommend the following feed rate table for your reference, when the thickness changes, the cutting speed can be Press the cutting area (cm2/min) to conversion. Tip: The first feed or each piece of board should be reduced by half for the first three walks.
9, the cutting depth for medium hard stone such as marble, limestone cut through at once, for hard stone and abrasive such as large granite, sandstone should step cutting, saw cutting granite monolithic, eating knife depth is generally 10-20mm , depth of cut marble cutting 50-100mm, more than double-sided cutting hard granite, depth of cut of each 3-5mm, should be based on the hardness of the stone, using a saw blade and the fixed performance, efficiency recommend the following table for your reference. Common materials cutting efficiency table Note: "1" indicates low power finishing; "2" indicates a high power roughing.
10, the blade rotation direction of the ring saw blades  same stone as the feed direction along the cutting, contrary to reverse cutting, and reverse cutting, due to an upward vertical force component, in the form of stone off potential, therefore, is a solid stone, under the same conditions Next, you should try using smooth cutting. When using reverse cutting, cutting depth to be reduced, generally reduced to shun cutting 1/3-1/2.
11 In summary, the basic requirements for selection cutting process are: low hardness, good stone cutting performance can be deeply walking, brisk walking contrary shallow cut, ie corresponding to the same stone and saw and saw blade should be cutting efficiency, cutting board, good quality, long life blade and matrix process parameters prevail, the four complementary and mutually dependent, must not generalize. For example, when the saw blade cutting speed can not be maintained, indicating a blunt blade, cutting depth should be reduced while increasing the cutting speed to sharpening blades.