Resin grinding wheel can not be stored in damp places

Insist on using the FIFO principle , be used during the best use to ensure wheel, resin grinding wheel use during the warranty period , if more than one year will need re-testing its strength and appearance , may continue to use the check. Wheel, resin grinding wheel requires a full , tight packaging , so as to ensure that transportation to and from the course without collisions. During transport needs careful not to get wet , away from alkalis items. Resin wheel to wheel and usually square and placed neatly , try  concrete ring saw not to tilt, do not let their pressure and prevent deformation. Wheel in the store when the use of wooden pallets Gechao mopping -out , avoid direct contact with the ground , from the ground requires 10cm to 15cm, the maximum height does not exceed 1m. The company has advanced production equipment and first-class technology . Product quality and perfect after-sales service , the main production and operation : ceramic grinding wheel, resin grinding wheel , abrasive series and other electrical products.
The wheel up from the melt rotation , relying on rotating grinding wheel blows excess impregnant . Whetstone holding abrasive grinding wheels  time in the air for 1-1.5 hours . Wheel according to this specification discard excess impregnant not formed on the diamond trimming the tumor , while the grinding surface of the plug is not greasy , and will not produce burns on the surface to be ground . Vintage stearyl wheel and immersion treatment is sulfur impregnation of the substrate to process a variety of wheel technology, can improve grinding performance, but there are some defects in the process of handling the final result is often used to reduce the effect of wheel . Our analysis of the reasons that these components can form a homogeneous melt , stearyl distributed above and below the sulfur distribution in  tile cutting blades contrast , modern technology is dipping treatment on the development of conventional treatment , were then placed in was heated to 130-135 ℃ impregnant composition in the melt , from 2.8 rpm / sec to stop the fall of the pulse with the rotation speed of four minutes . This will ensure that all components of impregnation evenly soaked in the wheel .